Hermetically Sealed DC-LVDT Position Sensors Operate in Corrosive Environments

Macro Sensors, a sensor company specializing in the manufacture of LVDT-based linear sensors and gaging probes, offers a family of hermetically sealed sensors for general industrial use. Enclosed in a heavy wall, stainless steel housing, the HSE/HSER 750 Series of 3/4" diameter DC-operated LVDTs are impervious to dirt, water, steam and other corrosive elements. Units are designed for use in hydraulic cylinder positioning, valve position sensing, automatic assembly equipment and other industrial applications with hostile conditions.

In addition to its heavy-duty housing, the sensor's coil windings are sealed against hostile environments to IEC standard IP-68. This allows for free movement of the core, while sealing out the surrounding media from the winding. The housing, bore liner and end washers are TIG welded, providing a hermetic sealing free from oxidation-producing faults that may cause leakage.

"LVDTs often must operate in environments where they are surrounded by corrosive or pressurized media," said Ed Herceg, North America sales manager, Macro Sensors. "By prohibiting media to enter the sensor windings, hermetic sealing protects the life and reliability of the LVDT in these conditions."

A single-ended LVDT, the HSE Series 750 units terminate through a sealed axial connector that prohibits the core from passing completely through the coil assembly. Electrical termination for the HSER Series 750 DC-LVDTs, however, is made through a sealed radial connector located near one end. The radial connector offers a through-bore design that permits access to either ends of the LVDT's core for better mechanical support and core guidance, and easier cleanout. The radial connector also offers a shorter installed length.

Incorporating built-in electronics, both the HSE/HSER 750 Series 750 sensors provide the features of an AC-LVDT, such as frictionless operation and dynamic response, with the added convenience and simplicity of DC input and pre-calibrated DC output. Units operate in conjunction with PLCs, digital indicators, A/D converters, computer-based data processors and QC data collection systems.

Available in ranges of 0.100" (2.5mm) to 20.00" (500mm), the HSE/HSER 750 Series LVDTs feature high resolution, repeatability (repeatability error <±0.01% of FSO), and low hysteresis (hysteresis error <±0.01% of FSO). Standard maximum linearity error for any of these DC-operated sensors is ±0.25% of full scale output using a statistically best-fit straight line derived by the least squares method. A linearity error of less than or equal to ±0.10% of full-scale output is available as an option.

Operating from 24V DC (nominal) or 15-24V DC ±10%, 30 mA (nominal), the HSE/HSER Series 750 LVDTs offer a full-scale output 0 to 10V DC. Operating temperature range is 0° to +160°F (-20°C to +70°C). Units are qualified at pressures up to 1000 psi (70 bars) and are designed for numerous high-pressure applications.

Macro Sensors offers several standard options that permit a user to customize HSE/HSER Series 750 LVDTs, including Teflon bore liners and metric threaded cores. In addition, Macro Sensors can provide mounting accessories, core extension rods, and DC power supplies. A mating connector plug is supplied with every unit.

For more information contact:

Eileen Otto

Macro Sensors

7300 US Route 130 North, Bldg. 22

Pennsauken, NJ 08110-1541

856-662-8000

Fax: 856-317-1005

www.macrosensors.com

www.lvdts.net

www.astsensors.com 

E-mail: lvdts@macrosensors.com